Model 41 Magazine Base Plate Repairs

Do you have any tips to help others? Please post them here.

Moderator: carlson1

User avatar

Topic author
rbwhatever1
Senior Member
Posts: 1429
Joined: Mon Mar 18, 2013 7:16 pm
Location: Paradise Texas

Model 41 Magazine Base Plate Repairs

Postby rbwhatever1 » Sun Mar 15, 2015 12:45 pm

I bought a few spare Smith & Wesson magazines for my Model 41 at the Lone Star Gun Show yesterday since they're very hard to find. These new in the box magazines from Smith & Wesson would not seat in the pistol. The floor plates on my older magazines have a hole to push the detent pin for removing the floor plate, spring and follower. Easy cleaning. The floor plate on these magazines have no detent spring hole and were not flush with the bottom of the magazine. The gap was pretty big.

I used a small allen wrench to grab the locking pin through the slot on the side of the magazine to slide the spring towards the follower to remove tension (and the enclosed detent pin from the hole in the floor plate) to slide it out. I cranked the tapered (closed) ends of the floor plates in a bench vise and the gap closed tightly.

The base plates are now sealed in the bottom of the magazine when assembled and no issues loading or ejecting the new magazines. No issues firing.

I also bought spare TSW4566 Magazines and these were fine.

Smith & Wesson should have better standards for whomever makes their Model 41 magazines. I edited this photo to show where the gap was...

Image
III

Return to “"How To" Tips”

Who is online

Users browsing this forum: No registered users and 1 guest