Reloading Room Floor

Topics that do not fit anywhere else. Absolutely NO discussions of religion, race, or immigration!

Moderators: carlson1, Charles L. Cotton

Post Reply
User avatar
Senior Member
Posts: 1047
Joined: Wed Jan 06, 2016 10:20 am
Location: East Texas

Reloading Room Floor

Post by Lynyrd » Tue May 16, 2017 9:59 pm

If I ever get around to building a reloading room, I think I'm gonna make the floor out of brass casings like this.


Here is the DIY article about the penny floor.

I would have to flatten the brass, but wouldn't this be nice in brass?
Do what you say you're gonna do.

User avatar
Senior Member
Posts: 759
Joined: Wed May 02, 2012 10:31 pm
Location: Abilene, TX

Re: Reloading Room Floor

Post by SRO1911 » Tue May 16, 2017 10:07 pm

Take a bandsaw to all the junk brass (berdan primed, steel, aliminum, splits etc.) and cut the heads off - all at maybe 3/16 of an inch...section a few bullets lengthwise...throw in a few bargain bin firing pins, hammers-
That would be an awesome floor or better yet - bar top.
When any govt, or church,says This you can't read, are forbidden to know, the result is tyranny and oppression. Little force is needed to control a man who has been hoodwinked; no force can control a free man, not the rack, bombs, not anything, you can't conquer a free man, at most you can kill him.

Junior Member
Posts: 28
Joined: Fri Jan 20, 2017 10:20 pm

Re: Reloading Room Floor

Post by Odiferous » Wed May 17, 2017 7:17 am

Seems like it'd be too high maintenance for a workspace floor. But I agree, it'd be a killer bar top or coffee table. With the variety of case/primer combinations out there in each caliber, there's a ton of flexibility in the design.

Post Reply

Return to “Off-Topic”