TexasCHLforum.com

I purchased one from Cabela's sat that looked good but was a small of back model, so went back and came up bust. Well then went to CTD and looked at one of these, I read front to back in the holster rules and didnt see a big red flag.

The only flag I see that is raising this question is in NOT PERMITED
Letter H
" Cutting of the front edge of the holster more than 1 3/4" below breechface or 1" below the rear of the cylinder."

I have about 2" below the breechface maybe 2.5"

I am sure this cuts the mustard, if it doesnt will just have to order one. Seems like a modified pancake model though

The holster pictured is fine for IDPA. The "cut below the breehface" statement refers to a "speedcut" which is a cutout in the top of the holster, not cuttoff at the bottom.

You're good to go.

Thanks HV, keeps me from ordering one.

That one looks like it would be just fine for IDPA. Be sure you have a good sturdy belt to hold it in place and tight to your body.