Pre 1985 Rem 870 forend tube assembly
Moderator: carlson1
-
mojo84
- Senior Member
- Posts: 9045
- Joined: Tue Jun 21, 2011 4:07 pm
- Location: Boerne, TX (Kendall County)
Pre 1985 Rem 870 forend tube assembly
Mine broke and I can't seem to find a replacement anywhere. Not sure what all is involved in converting it to the newer version. Any advice or feedback would be much appreciated.
Last edited by mojo84 on Tue Aug 26, 2014 9:08 pm, edited 1 time in total.
Note: Me sharing a link and information published by others does not constitute my endorsement, agreement, disagreement, my opinion or publishing by me. If you do not like what is contained at a link I share, take it up with the author or publisher of the content.
-
mojo84
- Senior Member
- Posts: 9045
- Joined: Tue Jun 21, 2011 4:07 pm
- Location: Boerne, TX (Kendall County)
Re: Pre 1985 Rem 870 forend tube assembly
Thanks Andy. I was starting to think I needed to convert to the newer model. I didn't realize it would be as simple as buying a new slide assembly also. I have seen some reference to this since I made my original post. Appreciate your efforts and help.
Come to think of it, I have a Dremel and air compressor with a grinder tool. I may just try that and save a little.
Come to think of it, I have a Dremel and air compressor with a grinder tool. I may just try that and save a little.
Last edited by mojo84 on Tue Aug 26, 2014 9:17 pm, edited 1 time in total.
Note: Me sharing a link and information published by others does not constitute my endorsement, agreement, disagreement, my opinion or publishing by me. If you do not like what is contained at a link I share, take it up with the author or publisher of the content.