TexasCHLforum.com

Good job. I bought one of those lead heaters a year ago and have not yet tried casting bullets.
Got lots of ingots now though :)

Andy, where are you getting your lead from?

What's the trick to avoiding voids ?

I think all of mine is wheel weights.
So can I use tin from lead-free plumbers solder, or is there a correct source?

I have most of the stuff to take start loading..I just need time and a few pointers. I bought the lead, molds, and handles a year ago along with the Lyman instruction manual.

Jason

jbirds1210 wrote:I have most of the stuff to take start loading..I just need time and a few pointers. I bought the lead, molds, and handles a year ago along with the Lyman instruction manual.
Jason

Jason, I'm in the same place, got all the gear, need powder, bullets & time

I'm pretty close, may take you up on that next time you have the rig out.

I'll pick up some 45 molds next trip to Cabelas.

Do those shorts make me look fat?

The Annoyed Man wrote:Do those shorts make me look fat?

No. They're quite attractive....You know, in a manly sorta way.

I bet he'd lose some of that manliness with a little lead splatter on those bare legs

USA1 wrote:

The Annoyed Man wrote:Do those shorts make me look fat?

No. They're quite attractive....You know, in a manly sorta way.

Maybe I should get some Jorts?

Rex B wrote:I bet he'd lose some of that manliness with a little lead splatter on those bare legs

Ouch!

Now that would make a Kodak moment.