Page 1 of 1
Question on AR15 optics set up
Posted: Fri Dec 16, 2011 4:36 pm
by Munk
I am wanting to put my Eotech and 3x magnifier on my Daniel Defense M4. I want to leave the iron site on. Is there a proper spacing I should be aware of looking down the rail? Iron site, 3X, Eotech, Iron site? How close should my 3x magnifier and Eotech be to each other?
Thanks!
Re: Question on AR15 optics set up
Posted: Fri Dec 16, 2011 4:47 pm
by The Annoyed Man
A picture is worth a thousand words. Here is the setup on mine:
The magnifier is mounted on a A.R.M.S. flip-to-side mount. You depress a lever on the left side of the mount, and the whole mount and magnifier flip over to the right side of the carbine. When the irons are deployed, they co-witness with the reticle in the EOTech sight.
The rear end of the rear sight lines right up with the rear end of the rail on the upper receiver. Hope that helps.
Re: Question on AR15 optics set up
Posted: Fri Dec 16, 2011 4:58 pm
by PUCKER
The Annoyed Man wrote:A picture is worth a thousand words. Here is the setup on mine:
The magnifier is mounted on a A.R.M.S. flip-to-side mount. You depress a lever on the left side of the mount, and the whole mount and magnifier flip over to the right side of the carbine. When the irons are deployed, they co-witness with the reticle in the EOTech sight.
The rear end of the rear sight lines right up with the rear end of the rail on the upper receiver. Hope that helps.
You have the same gun (well, it probably started out the same as mine....but yours looks nicer!) as me....I need to borrow it just for a few minutes...just teasing....nice setup!