TexasCHLforum.com

I have a stripped lower that I need to get some engraving work done on.


Does anyone know of a place in the Fort Worth/DFW that does this?


Also, what are the ramifications once I engrave it? Will it need to be recoated?


Thanks!

You don't have to have the lower refinished..he will treat where the engraving was done in black or left shiny.

AndyC wrote:http://dallasengraver.com

Also JR French and the legendary Robert Shade as backups outside DFW.

ARr-15 aluminum lower? Ideally, yes, but you can discuss options with the engraver.

+1 on Dallas Engraver. Ken is a member (treasurer actually) of our lodge and I have seen some of his work. He does some great work.

http://identmarking.com/" onclick="window.open(this.href);return false;

Based in Rockwell.

Laser engraving for all your Form 1 needs :)

If you're engraving for a form 1, you can clear coat over the exposed aluminum, but you want to leave the engraving open for anyone who needs to inspect it.

This one is in N. Dallas/Addison.

I've used them for a FFL transfer but not for any engraving.


http://www.tgunsight.com/aboutus.html" onclick="window.open(this.href);return false;

APynckel wrote:http://identmarking.com/

Based in Rockwell.

Laser engraving for all your Form 1 needs :)

If you're engraving for a form 1, you can clear coat over the exposed aluminum, but you want to leave the engraving open for anyone who needs to inspect it.

Heard nothing but good things about them. The dealer I purchased my suppressor from uses them for his SBR builds.

I just got my lower done by Ken yesterday and it turned out great!

For gun engraving for SBR, is it better to leave lower stripped or can you send complete lower?

I've always used iDent Marking. GREAT folks.

APynckel wrote:http://identmarking.com/

Based in Rockwell.

Laser engraving for all your Form 1 needs :)

If you're engraving for a form 1, you can clear coat over the exposed aluminum, but you want to leave the engraving open for anyone who needs to inspect it.

Another +1. My buddy and I used them for a couple SBR lowers. Walk in service, couldn't have been nicer/easier, and the results are very nice compared to traditional engraving.

They do lower receiver engraving at the shop my son works at: Bear Creek Firearms in Keller. They are a class III dealer / manufacturer, so they do this a lot.

I have a lower that needs to be engraved with the stamp comes back, and that's where I'm taking mine.

Come on, Guys, I'm not seeing any pictures.

bulinm wrote:Come on, Guys, I'm not seeing any pictures.

Click on the link for Dallas Engravers above.

The Annoyed Man wrote:They do lower receiver engraving at the shop my son works at: Bear Creek Firearms in Keller. They are a class III dealer / manufacturer, so they do this a lot.

I have a lower that needs to be engraved with the stamp comes back, and that's where I'm taking mine.

bulinm wrote:Come on, Guys, I'm not seeing any pictures.

Pre-Engraving:



I haven't got my form 1 filing back yet, so won't have an engraved receiver to show for a while, but the trust name will be engraved below the serial# on the right side.