Ruger New Model super Blackhawk Part

Diode · Post by **Diode** » Thu Nov 23, 2006 8:42 pm

I am not good with the correct names for Revolver parts yet and I need to find one. I am looking for the pin and spring that holds the shaft in that runs through the cylinder. I believe it would stick out on the left side. Could someone tell me what it is called? I need to try and find one and I dont know what to ask for

My guess would be a latch pin?

Texasdoc · Post by **Texasdoc** » Thu Nov 23, 2006 9:02 pm

diode, here is a break down picture of a New Super Blackhawk the parts you need if I understand it is the Base pin latch. in the picture parts XR-27 & 47

I hope this helps

http://stevespages.com/ipb-ruger-superblackhawknew.html

300shooter

dws1117 · Post by **dws1117** » Thu Nov 23, 2006 9:15 pm

When did you get that? You didn't have it earlier today, or did you?

You have become a wheel gun addict.

Diode · Post by **Diode** » Thu Nov 23, 2006 10:39 pm

Thanks 300! No DW it's not mine :)

dws1117 · Post by **dws1117** » Thu Nov 23, 2006 10:46 pm

Ok, I was starting to worry. I thought didn't like "cowboy guns".

JLaw · Post by **JLaw** » Fri Nov 24, 2006 6:53 am

dws1117 wrote:Ok, I was starting to worry. ".

Me to dw, I thought he was holding out on us!

JLaw

Diode · Post by **Diode** » Fri Nov 24, 2006 8:39 am

You guys are too much, We will have to shoot it. You know to test the little part I have to find

Diode · Post by **Diode** » Fri Nov 24, 2006 8:39 am

300shooter wrote:diode, here is a break down picture of a New Super Blackhawk the parts you need if I understand it is the Base pin latch. in the picture parts XR-27 & 47

I hope this helps

http://stevespages.com/ipb-ruger-superblackhawknew.html

300shooter

Thanks so much! I think you nailed it.