TexasCHLforum.com

Hello everyone, just wanted to make this post for myself and others, so we will all know the proper techniques.

Bolt

cajunautoxer wrote:Bolt

Yeah + charging handle, buffer/spring.

Saying lube the bolt is sort of simplifying it - get all the parts of the Bolt Carrier Group.

I cant access the ar15.com forum (work computer) but there is a sticky that shows all the lube points. If i remember correctly, it is in the ar15 section under "maintenance and cleaning".

Ok thanks everyone.

http://www.ar15.com/forums/t_3_7/548967 ... OINTS.html" onclick="window.open(this.href);return false;

and...

[youtube]http://youtube.com/watch?v=xW4DQ5QlwrA[/youtube]

The simplest answer is, if it moves oil it. Way more AR15 malfunctions come from too little lube than too much. Use a good high quality lubricant but, any oil is better than none.

I don't shoot as much anymore but I had an AR that went a couple thousand rounds between shooting and all I did was lube the BCG. And had no problems. But I'm lazy. I don't want guns that need to be cleaned after every range trip or match

gigag04 wrote:

cajunautoxer wrote:Bolt

Yeah + charging handle, buffer/spring.

Saying lube the bolt is sort of simplifying it - get all the parts of the Bolt Carrier Group.

There are 4 "rails" the BCG basically ride on. I put grease on those. If you don't like grease then oil is fine but blows off after a lot of shooting on DI guns. Either take the bolt out of the Bolt carrier and lube it or you can also add oil in the two small holes on the side of the BCG. I don't grease the locking lugs but some people do. I also don't lube the firing pin but I think some people lube it as well.

While I don't clean or oil "Charlene" before shooting, immediately after even 1 round I completely disassemble the BCG and wipe down/clean everything with one of those Rem Oil wipes. Scrape any residue you see (the firing pin on mine gets bad quick). Also I use a q-tip soaked in Rem Oil to clean the gas key and gas tube where they contact each other. A few drops around the moving parts of the trigger group is nice as well.

As stated in the video above I only lubricate the "rails" on the bolt and occasionally run a cloth through the bore and hit it with a chamber brush ( about every 1000-2000rounds). I do blast out the gas tube with brake cleaner and compressed air and then in a very small pipe cleaner inside to remove any remaining particles but that's only been done twice(after about every 5000 rounds) I do prefer a lightweight grease over oil.

packa45 wrote:As stated in the video above I only lubricate the "rails" on the bolt and occasionally run a cloth through the bore and hit it with a chamber brush ( about every 1000-2000rounds). I do blast out the gas tube with brake cleaner and compressed air and then in a very small pipe cleaner inside to remove any remaining particles but that's only been done twice(after about every 5000 rounds) I do prefer a lightweight grease over oil.

So you grease the carrier rails, but no lube on the bolt itself?

Yes I do lube the bolt lightly. Sorry to leave that out.

James Yeager at Tactical Response has good, short video on youtube titled AR 15 lubrication, I hesitate to post due to forum rules; ie Mr. Yeager apparently is, as am I, a member in good standing of the Ancient and Honorable Order of Turtles.

RoyGBiv wrote:http://www.ar15.com/forums/t_3_7/548967 ... OINTS.html

and...

[youtube]http://youtube.com/watch?v=xW4DQ5QlwrA[/youtube]

That's a great video. Thanks Roy.